Tata Steel reports pre-tax loss of Rs 6.5 crore, net sales down 15.4%

Tata Steel reported a loss of Rs 6.54 crore before tax on a consolidated basis in the September quarter (Q2) against a profit of Rs 5,411 crore in the corresponding period last year, mainly due to a fall in realisations across geographies.

The loss is after exceptional expenses that include gain on non-current investments, restructuring and other provisions, totalling Rs 33.56 crore for Q2 versus a gain of Rs 163.77 crore in year ago quarter. Even if these are excluded, the company's managed a pre-tax profit of only Rs 27.02 crore in Q2. Net sales stood at Rs 33,954 crore in the period under review, down 15.4 per cent from last year as realisations declined significantly amid weak demand in the domestic market.

“The business environment in India and other geographies continued to be challenging and weighed heavily on steel prices. Sequentially, realisations fell by Rs 4,000 per tonne which impacted the top line,” said T V Narendran, chief executive officer and managing director, at the earnings conference.

Without the favourable tax, the firm’s operating performance was dismal as its comparable/adjusted Ebitda stood at Rs 4,018 crore, versus Rs 8,641 crore in the same period last year. 

During the quarter under review, the company had a favourable tax impact of Rs 4,233 crore, of which Rs 2,425 crore was due to adoption of the new corporate tax rate by Tata Steel (standalone) and some of its subsidiaries in India. Also, Rs 1,808 crore was on account of recognition/ reversal of deferred tax assets (DTA) and liabilities in offshore subsidiaries. 

These lent support to the bottom line as the company reported a consolidated net profit of  Rs 3,302 crore in the September quarter, up 6 per cent from the corresponding period last year.

According to Bloomberg estimates, the company’s net sales was seen at Rs 34,476 crore in the September quarter, while its bottom line was expected to be at Rs 338 crore.

Consolidated adjusted earnings before interest, tax, depreciation and amortisation (Ebitda) margin stood at 11.6 per cent in the quarter gone by with Ebitda per tonne at Rs 6,155. For the India business, despite the challenging environment, Ebitda margin was comparatively healthy at 22.4 per cent with Ebitda per tonne at Rs 11,200. Considering the weak demand scenario, the management said it has reduced capex guidance for FY20 to Rs 8,300 crore from Rs 11,000 crore earlier and that the capex could see a sharper recaliberation, going ahead, depending on the market condition. As on September 30, the company’s net debt stood at Rs 1,06,952 crore and gross debt was at Rs 1,11,549 crore.

“While our gross debt increased during the quarter due to an increase in working capital, we have renewed our focus on cash flow maximisation through operational improvements, working capital reduction and rationalisation of capex which will help us deleverage,” said Koushik Chatterjee, executive director and chief financial officer. 

During the quarter, the company tied up $525 million of foreign currency loans which will help lengthen the debt maturity profile. The company said its liquidity position continues to be strong with cash balance of Rs 4,596 crore and unutilised bank lines of Rs 7,262 crore.

Tata Steel had plans to lower debt by $1 billion for FY20 and has repaid euro 370 million so far. While the management informed that it will not be able to meet the $1 billion repayment target this year, repayment of a similar tranche (of close to euro 370 million) could take place by January-February 2020.

In the September quarter, Tata Steel Europe’s liquid steel production was impacted by weak market conditions, planned summer shutdowns and unplanned outages. 

Tata Steel Europe has launched a transformation programme to make operations simpler, leaner and sustainable for long-term success, it said.